Blank screen or a screen in power saving mode on the Connect+ Series, SendPro P

Issue

Your meter's display is black, blank or in power saving mode.

Cause

The display may be turned off, disconnected, or malfunctioning.

Resolution

Solution 1: Ensure your meter is turned on

1. Ensure that the blue power light on the front of your meter is turned on.
   
2. If the light is off or blinking, press the power button to power up your meter.
3. If the meter does not power up within a few minutes, ensure that the power cord plugs into a functioning wall outlet.

Solution 2: Check your connections and device statuses

1. If you have the optional 15-inch display, there is a power button on the lower right corner along with a power led. It also has an external power adapter instead of a power cable running through the tower.
2. Your meter's display can show No Signal if the display is powered on, but the meter is off or the VGA cable is loose or disconnected.
3. Sometimes the vibration from tapping the screen causes the cables to loosen on the display. Check that all of the connections on the back of the display are tight and secure:
   • There is a 15-pin VGA that plugs into the left side of the meter.
   • There is a USB cable that connects to into the left side of the meter.
   • There is a power cable that runs into the display mounting tower.

Related topics

• Resolve a frozen screen on the Connect+ Series, SendPro P ​