Refilling the envelope and tape sealant bottle on the SendPro MailCenter 1000, 2000, and 3000

Your mailing system displays a message telling you when your E-Z Seal® is running low. When you receive this message, your system can still seal approximately 50 envelopes.

Pitney Bowes recommends using E-Z Seal because it helps keep your moistener tank clean and improves sealing performance. Refill the sealant bottle when your E-Z Seal is running low.

1. Lift the sealant bottle out of the cradle. The bottle is located to the right of the printer module, behind the stacker.
2. Remove the cap from the bottle.
3. Add enough E-Z Seal to bring the level up to the bottom of the throat of the bottle. Do not overfill the envelope sealant bottle.
4. Replace and tighten the cap and return the bottle to its original position.