Loading the high capacity envelope feeder on the DI900, DI950, and Relay 5000-8000

Adjust the side guides:

1. Place an envelope in the bottom of the feeder, between the side guides.
2. Using the blue adjuster knob, bring the side guides in to lightly touch the envelope.
3. Release the knob. The guides will spring back to the correct position to allow free sliding of the envelope between the side guides. Note: Side guides only spring back after they are moved inward.
4. Make sure that the envelope slides freely between the side guides when it is placed flat on the red feed belts.

Adjust the HCEF wedge:

1. Insert an envelope into the HCEF with the bottom edge of the envelope against the centre guide, in line with the two screws. The top edge of the envelope (the edge with the flap) should point towards the wedge. Note: Ensure that the envelope is centred, not angled, on the centre guide to obtain correct positioning. If the position of the envelope is incorrect, the Separator Gap adjustment will be incorrect as well.
2. Push up and release the blue Wedge Locking Lever.
3. Slide the wedge toward the envelope until the top edge of the envelope fits into the centre slot of the wedge.
   
4. Push down on the Trail Prop Locking Lever to lock the wedge into place and remove the envelope.

Adjust the HCEF Separator Gap:

1. Lift up the separator gap adjusting lever.
2. Place the envelope, bottom edge first, under the separator roller, so that the top edge (flap crease) lines up with the edge of the tab on the wedge. Note: The edge of the tab is indicated by two arrows.
3. Lower the separator completely, then push down on the separator gap lever to lock it into place.

Load the HCEF:

1. Pull the envelope out from the HCEF.
2. Shingle a 20 mm to 50 mm stack of envelopes. Place the envelopes into the HCEF flap side down, flap last.
3. Finish loading a full stack of envelopes (up to 500 pieces), making sure that the envelopes contact the back of the side guides. It is not necessary to shingle the remaining envelopes.