Troubleshooting envelopes not feeding into the Connect+ Series and SendPro P

Learn how to resolve envelopes not feeding into the Connect+ 500W, Connect+ 1000, Connect+ 2000, Connect+ 3000, SendPro P1000, SendPro P1500, SendPro P2000, and SendPro P3000
Products affected: Connect+® 500W, Connect+® 1000, Connect+® 2000, Connect+® 3000, SendPro® P1000, SendPro® P1500, SendPro® P2000, SendPro® P3000

Issue

Envelopes are not feeding into the Connect+ or SendPro P

Cause

This issue can be caused by a number of factors:
  • The envelope dimensions are outside of the acceptable range.
  • The envelopes are not stacked properly on the feed deck.
  • The thickness adjustment knob setting is incorrect.
  • The stack of envelopes is leaning away from the feeder.
  • Too many envelopes are on the feed deck.
  • The envelopes are too heavy or too thick.
  • Worn, damaged or missing belts or rollers.

Resolution

  1. Ensure that the envelopes meet the specifications listed in the Operator Guide.
  2. Sort the mail by envelope size. All envelopes in a single stack should be the same size.
  3. Shingle the envelopes so the bottom envelope feeds first. This is not necessary if your mailing machine is running in WOW mode.
  4. If your mail pieces are sealed, fan them to make sure they are not stuck together as a result of previous processing.
  5. Place the stack of mail on the feed deck. Place the envelopes with the flaps down and against the rear wall.
  6. Make sure that the envelopes are pushed far enough so that they cover the feed sensor located on the feed deck near the rear wall.
  7. Adjust the side guide so that it is close to, but not touching, the bottom edge of the envelope stack. Be sure to leave a slight clearance between the side guide and envelopes (about 1.5 mm clearance).
  8. Use the thickness adjustment knob to adjust for envelope thickness.
    • If envelops are not getting past the thickness adjustment knob, set it to a higher setting.
    • If too many envelopes are being fed, set the thickness adjustment knob to a lower setting.
  9. If the feed motor is not starting, clean the feed sensor at the back wall near the entrance of the franking machine.
  10. Using a can of non-flammable canned air and working from the left side of the franking machine to the exit, blow onto the feed deck that the envelopes/tape sheets travel on. Ensure that all dust and debris are removed.

UPDATED: 16 May 2024