Printing a test label print on the PB-SP100 and w1110 Printers

Print a test label can check whether the printer has any problems.

To print a test print

1. Make sure that the label roll has been installed properly. To do this spread the label holder then insert the label roll into the printer.

2. Pull the label roll under the guides and out to the front of the printer.

3. Close the cover and press the Feed button to feed the label.

4. Turn on the power while holding down the Feed/Cancel button until the test label begins to print. This may take around 10 seconds.

The test label with show the current printer configuration information. After the self-test results are printed, a printer enters into print ready mode.